Table of Contents
Advertisement
LabMaster 10 Zi Oscilloscopes
Touch any of the measurements on the table display (under the grid
display area) to show its corresponding Measure dialog.
Parameter Setup
1.
Touch the parameter tab (Px) of an unused location or one that
you want to change.
2.
Under Type, select a measurement type:
on the waveform as indicated on the Source1 control.
subtraction, multiplication, division) on parameters indicated on
the Source1 and Source2 controls.
132
Measure On Waveforms applies measurements directly
Math On Parameters performs math (addition,
LM10Zi-GSM-E Rev A
Advertisement
Table of Contents
