Table of Contents
Advertisement
The Signal Display Grid
The grid area is divided into 8 vertical divisions and 10 horizontal
divisions just like any other oscilloscope. Set up the signal display area
by touching Display → Display Setup... from the menu bar. The Display
dialog offers a choice of grid combinations and can also set the grid
intensity.
There are several indicators on the grid to help you understand the
following:
Trigger Delay - This indicator is located along the bottom edge of
the grid. Trigger delay allows you to see the signal prior to the
trigger time.
All trigger delay values (including post-trigger delay, shown here)
are displayed in the Timebase Descriptor Label. Zero delay is the
horizontal center of the oscilloscope display.
The default setting (Time) is for delay readout (in seconds) and to
move proportionately when the timebase knob is turned. If you
want to set delay (Div) to a fixed position on the grid, and then
LM10Zi-GSM-E Rev A
Getting Started Guide
55
Advertisement
Table of Contents
