Power Cable And Main Power Switch - Teledyne LabMaster 10 Zi Series Operator's Manual

Power Cable and Main Power Switch

Teledyne LeCroy advises that you note the power ratings of the
individual modules and connect them to suitably rated circuits.

MCM-Zi Control Module comes with an IEC60320 Type C13
power inlet connector.

LM10xx-Zi Acquisition Module comes with an IEC60320 Type C20
power inlet connector.
CAUTION: The combined draw from your Master Control
Module and Acquisition Modules (max of 20) can be many kilowatts.
Two acquisition modules connected to a single circuit may cause an
overcurrent condition for that circuit.
When all connections are made, the main power switch on the front of
the Master Control Module powers on all components as a single unit.
NOTE: If any connections are incorrect, the main power switch will not
power on the system.
Always refer to the product datasheet at www.teledynelecroy.com for
the most current and detailed specifications.
LM10Zi-GSM-E Rev A
Getting Started Guide
31