Moving Traces From Grid To Grid; Displays Containing Masks; Dual Display Grid Selection - Teledyne LabMaster 10 Zi Series Operator's Manual

Moving Traces from Grid to Grid

You can move traces from grid to grid with the touch of a button.
1.
Double-touch the trace descriptor label to activate the waveform
you want to move and open the setup dialog.
2.
Touch the Next Grid shortcut button at the bottom of the setup
dialog.
NOTE: If you have only one grid open, a second grid
automatically opens when you select Next Grid.
You can also move a trace from one grid to another by dragging the
descriptor box to the desired grid. This is a convenient way to quickly re-
arrange traces on the display.

Displays Containing Masks

Since masks are pixel-based display renderings, you can think of them as
part of the Display feature set on your instrument. Masks and mask
testing are applied to waveforms as part of Pass/Fail functionality
accessed from Analysis → Pass/Fail from the menu bar.
NOTE: For more detailed information about Masks and other Pass/Fail
functionality, such as removing a mask from your display, refer to Mask
Testing (on page 158).

Dual Display Grid Selection

Make a dual grid display selection for showing on an external display
(once properly connected to the I/O panel) by selecting Display →
Display Setup.... Numbered labels on this image correspond with the
following steps.
NOTE: First-time setup may show a different Display tab. Fix this by
touching File → Exit on the menu bar and re-launching the oscilloscope
software using the Start DSO shortcut on the desktop.
LM10Zi-GSM-E Rev A
Getting Started Guide
117