Table of Contents
Advertisement
LabMaster 10 Zi Oscilloscopes
Cable De-Embedding option allows you to quickly specify the
characteristics of the cables (typically found on the cable's data
sheet) in your test setup and analyze your signal with the effects
of the cables removed.
NOTE: The Cable De-Embedding checkbox is only available if you
have the option. To learn more about this software option,
Contact Teledyne LeCroy for Support.
Interpolation - Linear interpolation, which inserts a straight line
between sample points, is best used to reconstruct straight-
edged signals such as square waves. (Sinx)/x interpolation, on the
other hand, is suitable for reconstructing curved or irregular
wave shapes, especially when the sample rate is 3 to 5 times the
system bandwidth.
Noise Filter - Enhanced Resolution (ERES) filtering increases
vertical resolution, allowing you to distinguish closely spaced
voltage levels. The tradeoff is reduced bandwidth. The
functioning of the instrument's ERES is similar to smoothing the
signal with a simple, moving-average filter. Use ERES on single-
shot waveforms, or where the data record is slowly repetitive
(when you cannot use averaging). Use it to reduce noise when
your signal is noticeably noisy, but you do not need to perform
noise measurements. It also may be used when performing high-
precision voltage measurements: zooming with high vertical gain,
for example.
Optimize - See Response Optimization Modes
88
(on
)
page 89
.
LM10Zi-GSM-E Rev A
Advertisement
Table of Contents
