Teledyne LabMaster 10 Zi Series Operator's Manual page 136


Vertical Abs - Provides a single, dashed, horizontal line and cross-
hair marking for the specific cursor location. None of the Show
controls are provided; however, the Position 1 control is enabled
on the right of the dialog.

Vertical Abs - Provides a single, dashed, horizontal line and cross-
hair marking for the specific cursor location. None of the Show
controls are provided; however, the Position 1 control is enabled
on the right of the dialog.
S (
HOW FOR
Show controls (Absolute, Delta, Abs+Delta, and Slope) become
available on the dialog when Relative Cursors (Horizontal or Vertical Rel
cursor types) are chosen.
For Horizontal and Vertical Rel cursor types, you can also specify
Position 1 and 2 time values for your cursor locations. You also have the
option to mark the Track checkbox which allows you to move your
Position 1 cursor (using the touch-screen display or front panel control)
and have both cursors then move together and maintaining their
relative distance from their originally specified positions.
The Show controls essentially display cursor value results on the signal's
corresponding Trace Descriptor label as follows:

Absolute - The Trace Descriptor label shows specific voltages for
the position location values provided.

Delta - The Trace Descriptor label shows the difference between
the specific voltages for the position location values provided.

Abs+Delta - The Trace Descriptor label shows both the specific
voltages and the difference between the specific voltages for
the position location values provided.

Slope - The Trace Descriptor label calculates the slope based on
the position location values provided.
LM10Zi-GSM-E Rev A
R C
ELATIVE
T
URSOR YPES
Getting Started Guide
)
129