Vertical Front Panel Controls - Teledyne LabMaster 10 Zi Series Operator's Manual

LabMaster 10 Zi Oscilloscopes

Vertical Front Panel Controls

NOTE: You can turn channels on and off using the software as explained
in Vertical Overview (on page 85) or from the front of the LabMaster
Acquisition Module.

Channels – Control channel ON/OFF and which channel is active
for the Vertical Offset and Volts/Div knobs controls. If a channel
is OFF, pressing that channel button turns it on and makes it
active. If a channel button is ON, pressing that channel button
makes it active, and then pressing it a second time turns it OFF.

Offset - Toggles between a zero vertical offset value and the
previous vertical offset value for the selected channel. Turn to
change the vertical offset value for the selected channel.

Gain - Toggles between fixed and variable gain adjustment. Turn
to change the gain value.
NOTE: Front panel Channel buttons are only lit when Channels 1
through 4 are active; however, Gain and Offset knobs will control any
channels from any connected acquisition module. Touch the display
Trace Descriptor Label to activate the channel before using the front
panel knobs to make desired Gain and Offset adjustments.
50 LM10Zi-GSM-E Rev A