Trace Descriptor Labels - Teledyne LabMaster 10 Zi Series Operator's Manual

S D
IGNAL ISPLAY
On the Signal Display Grid, the Pop-up menu
provides assistance while using the
oscilloscope.
Clicking on a waveform opens a pop-up menu.
From this pop-up menu, you can perform the
following functions:

Open the Setup dialog for the trace

Turn the trace descriptor label off

Open the Math dialog for the trace

Open the Measure dialog for the trace

Annotate the selected trace

Trace Descriptor Labels

Shown just beneath the grid display, these boxes provide a summary of
your channel, timebase, and trigger settings.
When a trace is selected its corresponding descriptor label is shown
highlighted.
The C1 Trace Descriptor Label is selected; C2 is not.
Make vertical or horizontal channel adjustments by touching the
respective label. The setup dialog for the function is shown beneath.
Channel trace labels show the vertical settings for the trace and cursor
information (if cursors are in use). The title bar of the label includes
indicators for (SinX)/X interpolation, waveform inversion (INV), deskew
(DSQ), coupling (DC/GND), bandwidth limiting (BWL), and averaging
(AVG). These indicators have a long and short form, respectively.
LM10Zi-GSM-E Rev A
G P -U
RID OP
Getting Started Guide
M
P ENU
57