Persistence Histogram - Teledyne LabMaster 10 Zi Series Operator's Manual

LabMaster 10 Zi Oscilloscopes
4.
Select Show Histicons.
NOTE: For measurements set up in My Measure, you can quickly display
an enlarged histogram of a thumbnail histogram by touching the
Histicon you want to enlarge. The enlarged histogram appears
superimposed on the trace it describes. This does not apply to Std
Vertical or Std Horizontal measurements.

Persistence Histogram

You can create a histogram of a persistence display, specifying the
horizontal or vertical "slice" of the waveform to graph.
NOTE: This math operation is different than the Histogram math
operation and is not affected by Center and Width settings made on any
existing Histograms.
1.
Choose Math → Math Setup... from the menu bar to access the
Math dialog.
2.
Touch an open Fx button and select Phistogram from the pop-up
menu.
3.
Touch the Fx tab to open the Function dialog, then touch
Source1 and select a source trace from the pop-up.
4.
Touch the Phistogram tab at the right to open the Phistogram
dialog.
5.
Touch Slice Direction and select Horizontal or Vertical slice from
the pop-up menu.
6.
Touch Slice Center and use the pop-up keypad to enter a value.
7.
Touch Slice Width and use the pop-up keypad to enter a value.
P
ERSISTENCE
Using this math operator, you can enter the percent of the persistence
trace population to use in creating a new waveform.
146
T R
RACE ANGE
LM10Zi-GSM-E Rev A