Trigger Settings - Teledyne LabMaster 10 Zi Series Operator's Manual

NOTE: Although 50, 60, or 65 GHz inputs operate on Channels 2 and 3
only, Channel 4 would still be the input channel for the serial trigger
signal.
Complete information on the operation of this trigger can be obtained
in the Teledyne LeCroy Serial Data Debug Solutions manual posted on
the Teledyne LeCroy website.

Trigger Settings

All trigger Horizontal and Vertical adjustments are typically made using
either the Delay or Level knobs on the front panel of the instrument, or
else the corresponding software controls on the Timebase setup dialog.
Horizontal
Turn the D
ELAY
trigger's horizontal position. Or, touch inside the Delay control and
provide a value on the Timebase dialog using your preferred input
control method. Additional information on using the touch screen
controls can be found in the Dialog Area.
The trigger location is shown by a marker under the grid.
Post-trigger delay is indicated by a left-pointing arrow at the
lower-left of the grid.
The time value is given in the title line of the Timebase label at
the lower-right of the grid.
Vertical
Turn the L knob in the TRIGGER control group to adjust the trigger's
EVEL
vertical threshold.
LM10Zi-GSM-E Rev A
knob in the HORIZONTAL control group to adjust the
Getting Started Guide
103