Table of Contents
Advertisement
Getting Started Guide
Your test data is shown on the Table display area shown in the previous
screen-shot.
Pass/Fail Setup on Qx Dialogs
The Qx dialog contains several controls for specifying your Pass/Fail
conditions.
M
Q
D
C
AIN
X
IALOG
ONTROLS
Use the Source1 control to specify the waveform you'll use for your
Condition.
Set your Pass/Fail condition by touching the Condition control on the
corresponding Qx dialog. The Pass/Fail Condition pop-up is shown.
LM10Zi-GSM-E Rev A
151
Advertisement
Table of Contents
