Teledyne LabMaster 10 Zi Series Operator's Manual page 200

Use the Auxiliary Output to send the following signals to other
instruments:

function to trigger another instrument when the oscilloscope is
ready.

external oscilloscope.

varies based on your specific model, refer to datasheet
specifications at www.teledynelecroy.com for details); generates
a pulse when pass/fail testing is active and conditions are met.

to deskew multiple channels. The Fast Edge connection varies
based on model and is either SMA or BNC.
C
ALIBRATION
A calibration signal can be output from the Probe Calibration Hook on
the front of the oscilloscope. The following Calibration Output Signals
are available for use:

based on your specific model, refer to datasheet specifications at
www.teledynelecroy.com for details).


LM10Zi-GSM-E Rev A
Trigger Enabled - This function can be used as a gating
Trigger Out - This function can be used to trigger an
Pass/Fail - Allows you to set a pulse duration (which
Fast Edge - Some models provide this signal output used
O S
UTPUT
Square Wave - You can set a Frequency value (varied
DC Level - This is a reference level.
Off - This function turns off the Auxiliary Output signal.
IGNALS
Getting Started Guide
193