Teledyne LabMaster 10 Zi Series Operator's Manual page 86

1.
Touch Timebase → Horizontal Setup... on the menu bar.
2.
Click the Sequence tab.
3.
Under Acquisition Settings, touch inside the Num Segments data
entry control and provide a value using your preferred input
control method. Additional information on using the touch
screen controls can be found in the Dialog Area.
NOTE: The number of segments you choose to display can be less
than the total number of segments in the waveform. For
example, in the pop-up images above, the number of display
segments is 10, but the total number of segments entered in the
timebase dialog's Num Segments control is 100.
4.
Touch the Enable Timeout checkbox.
5.
Touch inside the Timeout data entry control and provide a
timeout value.
NOTE: Use the sequence mode timeout to automatically
interrupt the sequence acquisition if the timeout value is
exceeded without a valid trigger. The timeout period accounts for
LM10Zi-GSM-E Rev A
Setting up Sequence Mode (Adjacent)
Getting Started Guide
79