Aux Output - Teledyne LabMaster 10 Zi Series Operator's Manual

LabMaster 10 Zi Oscilloscopes

Aux Output

The Aux Output dialog allows you to specify Auxiliary and Calibration
Output details.
1.
If you want a specialized output, touch one of the following
buttons under Use Auxiliary Output For: Square Wave, Trigger
Enabled, Trigger Out, Pass/Fail, or Off.
NOTE: If Pass/Fail is selected on this Use Auxiliary Output For
section of the dialog, a Pulse Duration data entry control is made
available. Provide a value within your instrument's specified
range. Refer to datasheet specifications at
www.teledynelecroy.com.
2.
On the Use Calibration Output For section of the dialog, choose
Square, DC Level, or Off. If you want a 1 kHz, 1 V Square Wave,
touch the Set to 1 kHz, 1 V Square Wave button.
3.
If Square or DC Level is selected, enter these additional values:

If you selected Square, enter a Frequency .

If you selected Square or DC Level, enter an Amplitude
into 1 MΩ.
A O
UXILIARY
Calibration and other signals can be output through the connector
labeled AUX OUT.
192
S
UTPUT IGNALS
LM10Zi-GSM-E Rev A