Dell PowerConnect B-RX Configuration Manual page 320

8
Deploying a LAG
Port
2/1
2/3
2/5
Syntax: show lag <lag-name> [brief] [deployed] [dynamic] [keep-alive] [static]
Table 58
TABLE 58
This field...
Total number of LAGS
Total number of Deployed LAGS
Total number of Trunks Created
LACP System Priority /ID
LACP Long timeout
LACP Short timeout
The following information is displayed per-LAG in the show lag brief command.
LAG
Type
Deploy
Trunk
Primary
Port List
The following information is displayed per-LAG the show lag command for each LAG configured.
LAG configuration
Deployment
Port
Link
L2 State
248
[Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
1 1
1 1
1 1
describes the information displayed by the show lag command.
Show LAG information
Ports
Primary Port:
LACP Key
105 Yes L Agg
105 Yes L Agg
105 Yes L Agg
Displays...
The total number of LAGs that have been configured on the switch.
The total number of LAGs on the switch that are currently deployed.
The total number of trunks that have been created on the LAG. The total
number of Trunks available are shown also. Since keep-alive LAGs do not
use a trunk ID, they are not listed and do not subtract for the number of
trunks available.
The system priority configured for the switch .
The ID is the system priority which is the base MAC address of the
switch.
The name of the LAG.
The configured type of the LAG: static, dynamic, or keep-alive
Status of LAG deployment:
Y – yes, LAG is deployed.
N – no, LAG is not deployed.
The trunk ID number.
The primary port of the LAG.
The list of ports that are configured in the LAG.
List of ports configured with the LAG.
The primary port configured on the LAG.
The link aggegation key for the LAG.
The Trunk ID number.
The chassis slot and port number of the interface.
The status of the link which can be one of the following:
•
up
•
down
The L2 state for the port.
Syn Col Dis No No
Syn Col Dis No No
Syn Col Dis No No
BigIron RX Series Configuration Guide
Ope
Ope
Ope
53-1001986-01