Configuration Examples - Dell PowerConnect B-RX Configuration Manual

BigIron RX(config)# show span pvst-mode
PVST+ Enabled on:
Port
1/1
1/2
2/10
3/12
4/24
Syntax: show span pvst-mode
This command displays the following information.
TABLE 76
This field...
Port
Method

Configuration examples

The examples use two common configurations:
•
•
Tagged port using default VLAN 1 as its port native VLAN
In Figure
and 4 as tagged VLANs.
FIGURE 32
To implement this configuration, enter the following commands on the RX.
BigIron RX(config)# vlan-group 1 vlan 2 to 4
BigIron RX(config-vlan-group-1)# tagged ethernet 1/1
BigIron RX(config-vlan-group-1)# exit
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e10000-1/1)# pvst-mode
BigIron RX Series Configuration Guide
53-1001986-01
Method
Set by configuration
Set by configuration
Set by auto-detect
Set by configuration
Set by auto-detect
CLI Display of PVST+ Information
Untagged IEEE 802.1Q BPDUs on VLAN 1 and tagged PVST+ BPDUs on other VLANs
Tagged IEEE 802.1Q BPDUs on VLAN 1 and untagged BPDUs on another VLAN
32, a PVST+ configuration uses VLAN 1 as the untagged default VLAN and VLANs 2, 3,
Default VLAN 1 for untagged BPDUs
Displays...
The Brocade port number.
NOTE: The command lists information only for the ports on which
PVST+ support is enabled.
The method by which PVST+ support was enabled on the port. The
method can be one of the following:
•
Set by configuration – You enabled the support.
•
Set by auto-detect – The support was enabled automatically when
the port received a PVST+ BPDU.
Untagged IEEE BPDU for VLAN 1
Untagged PVST BPDU for VLAN 1
Tagged PVST BPDUs for VLANs 2, 3, 4
Port1/1
PVST/PVST+ compatibility
Cisco
device
Port3/2
12
341