Commands Available Under Lag Once It Is Deployed; Configuring Acl-Based Mirroring; Disabling Ports Within A Lag - Dell PowerConnect B-RX Configuration Manual

8
Deploying a LAG
If the no deploy command is issued and more than 1 LAG port is not disabled the command is
aborted and the following error message is displayed: "Error 2 or more ports in the LAG are not
disabled, un-deploy this LAG may form a loop - aborted." Using the forced keyword with the no
deploy command in the previous situation, the un-deployment of the LAG is executed.

Commands available under LAG once it is deployed

Once a LAG has been deployed, the following configurations can be performed on the deployed
LAG:
•
•
•
•
•
•
•

Configuring ACL-based mirroring

ACL-based mirroring can be configured for an individual port within a LAG using the acl-mirror-port
command, as shown in the following.
BigIron RX(config)# lag blue static
BigIron RX(config-lag-blue)# deploy
BigIron RX(config-lag-blue)# acl-mirror-port ethe-port-monitored 3/1
Syntax: [no] acl-mirror-port ethe-port-monitored [slot/port] | named-port-monitored [name]
Use the ethe-port-monitored option with the appropriate [slot/port] variable to specify a Ethernet
port that you want to provide ACL mirroring for.
Use the named-port-monitored option with the appropriate [slot/port] variable to specify a named
port that you want to provide ACL mirroring for.
NOTE
Mirror (analyzer) ports cannot be assigned to the 16x10G card. You can monitor traffic on 16x10
ports.

Disabling ports within a LAG

You can disable an individual port within a LAG using the disable command within the LAG
configuration as shown in the following.
BigIron RX(config)# lag blue static
BigIron RX(config-lag-blue)# deploy
BigIron RX(config-lag-blue)# disable ethernet 3/1
Syntax: [no] disable ethernet [slot/port] | named [name]
Use the ethernet option with the appropriate [slot/port] variable to specify a Ethernet port within
the LAG that you want to disable.
244
Configuring ACL-based Mirroring
Disabling Ports within a LAG
Enabling Ports within a LAG
Monitoring and Individual LAG Port
Assigning a name to a port within a LAG
Enabling sFlow Forwarding on a port within a LAG
Setting the sFlow Sampling Rate for a port within a LAG
BigIron RX Series Configuration Guide
53-1001986-01