Lldp Configuration Details; Resetting Lldp Statistics - Dell PowerConnect B-RX Configuration Manual

LLDP configuration details

The show lldp local-info command displays the local information advertisements (TLVs) that will be
transmitted by the LLDP agent.
NOTE
The show lldp local-info output will vary based on LLDP configuration settings.
The following shows an example report.
BigIron RX#show lldp local-info ports ethernet 4/1
Local port: 4/1
+ Chassis ID (MAC address): 000c.dbfa.f900
+ Port ID (MAC address): 000c.dbfa.f900
+ Time to live: 120 seconds
+ System name
+ Port description
+ System capabilities : bridge, router
+ 802.3 MAC/PHY
+ Link aggregation: not capable
+ Maximum frame size: 1522 octets
+ Port VLAN ID: 1
+ Management address (IPv4): 8.8.8.1
A backslash (\) at the end of a line indicates that the text continues on the next line.
The fields in the above output are described in the individual TLV advertisement sections in this
chapter.
Syntax: show lldp local-info [ports ethernet <slot num/port num> | all]
If you do not specify any ports or use the keyword all, by default, the report will show the local
information advertisements for all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.

Resetting LLDP statistics

To reset LLDP statistics, enter the clear lldp statistics command at the Global CONFIG level of the
CLI. The Brocade device will clear the global and per-port LLDP neighbor statistics on the device
(refer to
FastIron#clear lldp statistics
Syntax: clear lldp statistics [ports ethernet <slot num/port num> | all]
If you do not specify any ports or use the keyword all, by default, the system will clear lldp statistics
on all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.
BigIron RX Series Configuration Guide
53-1001986-01
: "RX8"
: "10GigabitEthernet4/1"
Enabled capabilities: router
Operational MAU type
"LLDP statistics" on page 273).
: auto-negotiation supported, but disabled
: 10GigBaseSR
Resetting LLDP statistics
9
277