Dell PowerConnect B-RX Configuration Manual page 291

•
•
•
•
•
Displaying global IP configuration information
To display IP configuration information, enter the following command at any CLI level.
BigIron RX> show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 207.95.11.128
enabled : UDP-Broadcast-Forwarding
disabled: BGP4 Load-Sharing
Static Routes
Index
1
Policies
Index
1
64
Syntax: show ip
NOTE
This command has additional options, which are explained in other sections in this guide, including
the sections below this one.
This display shows the following information.
TABLE 51
This field...
Global settings
ttl
arp-age
BigIron RX Series Configuration Guide
53-1001986-01
OSPF information – refer to
BGP4 information – refer to
DVMRP information – refer to
page 647
PIM information – refer to
page 607.
VRRP or VRRPE information – refer to
IP Address
0.0.0.0
Action Source
deny 209.157.22.34
permit any
CLI display of global IP configuration information
"Displaying OSPF information"
"Displaying BGP4 information"
"Displaying information about an upstream neighbor device"
"Displaying PIM Sparse configuration information and statistics"
"Displaying VRRP and VRRPE information"
IRDP Proxy-ARP
RIP DVMRP FSRP
Subnet Mask Next Hop Router
0.0.0.0 209.157.23.2
Destination
209.157.22.26
any
Displays...
The Time-To-Live (TTL) for IP packets. The TTL specifies the maximum
number of router hops a packet can travel before reaching the device. If the
packet's TTL value is higher than the value specified in this field, the
Brocade router drops the packet.
To change the maximum TTL, refer to
page 192.
The ARP aging period. This parameter specifies how many minutes an
inactive ARP entry remains in the ARP cache before the router ages out the
entry.
To change the ARP aging period, refer to
on page 188.
Displaying IP information
on page 712.
on page 814.
OSPF
VRRP
Metric Distance
1
Protocol Port
tcp http
"Changing the TTL threshold"
"Changing the ARP aging period"
7
on
on
on page 459.
1
Operator
=
on
219