Configuring The Spanning Tree Protocol; Garp Timer Cli Commands - Dell PowerConnect 5316M User Manual

Table 7-54. GARP Timer CLI Commands
CLI Command
garp timer {join | leave | leaveall}
timer_value
The following is an example of the CLI commands:
console(config)# interface ethernet g11
console(config-if)# garp timer leave 900
console(config-if)# end
console# show gvrp configuration ethernet g11
GVRP Feature is currently Disabled on the switch module.
Maximum VLANs: 223
Port(s) GVRP-
Status
------- --------
g11 Disabled
console#

Configuring the Spanning Tree Protocol

Spanning Tree Protocol (STP) provides tree topography for any arrangement of bridges. STP also
provides one path between end stations on a network, eliminating loops.
Loops occur when alternate paths exist between hosts. Loops in an extended network can cause
bridges to forward traffic indefinitely, resulting in increased traffic and reducing network efficiency.
The switch modules support the following Spanning Tree protocols:
206
Configuring Switch Module Information
Description
Adjusts the GARP application join,
leave, and leaveall GARP timer values.
Registration Dynamic VLAN
Creation
------------ ------------
Normal Enabled
Timers (milliseconds)
Join Leave
------- ------
200 900
Leave All
---------
10000