Enabling Or Disabling Bgp Neighbors - Dell S6100 Configuration Manual

To reset a BGP connection using BGP soft reconfiguration, use the clear ip bgp command in EXEC Privilege mode at the system
prompt.
When you enable soft-reconfiguration for a neighbor and you execute the clear ip bgp soft in command, the update database
stored in the router is replayed and updates are reevaluated. With this command, the replay and update process is triggered only if a route-
refresh request is not negotiated with the peer. If the request is indeed negotiated (after execution of clear ip bgp soft in), BGP
sends a route-refresh request to the neighbor and receives all of the peer's updates.
To use soft reconfiguration (or soft reset) without preconfiguration, both BGP peers must support the soft route refresh capability, which is
advertised in the open message sent when the peers establish a TCP session.
To determine whether a BGP router supports this capability, use the show ip bgp neighbors command. If a router supports the
route refresh capability, the following message displays: Received route refresh capability from peer.
If you specify a BGP peer group by using the peer-group-name argument, all members of the peer group inherit the characteristic
configured with this command.
• Clear all information or only specific details.
EXEC Privilege mode
clear ip bgp [vrf vrf-name] {* | neighbor-address | AS Numbers | ipv4 | peer-group-name} [soft
[in | out]]
• *: Clears all peers.
• neighbor-address: Clears the neighbor with this IP address.
• AS Numbers: Peers' AS numbers to be cleared.
• ipv4: Clears information for the IPv4 address family.
• peer-group-name: Clears all members of the specified peer group.
• Enable soft-reconfiguration for the BGP neighbor specified.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
BGP stores all the updates received by the neighbor but does not reset the peer-session.
Entering this command starts the storage of updates, which is required to do inbound soft reconfiguration. Outbound BGP soft
reconfiguration does not require inbound soft reconfiguration to be enabled.
Example of Soft-Reconfigration of a BGP Neighbor
The example enables inbound soft reconfiguration for the neighbor 10.108.1.1. All updates received from this neighbor are stored unmodified,
regardless of the inbound policy. When inbound soft reconfiguration is done later, the stored information is used to generate a new set of
inbound updates.
Dell>router bgp 100
neighbor 10.108.1.1 remote-as 200
neighbor 10.108.1.1 soft-reconfiguration inbound

Enabling or disabling BGP neighbors

You can enable or disable all the configured BGP neighbors using the shutdown all command in ROUTER BGP mode.
To disable all the configured BGP neighbors:
1 Enter the router bgp mode using the following command:
CONFIGURATION Mode
router bgp as-number
218 Border Gateway Protocol IPv4 (BGPv4)