Sflow Sample-Rate (Interface Version) - Dell 8 Command Reference Manual

sflow sample-rate (interface version)

Sets the number of packets that are skipped before the next sample is taken for a specific
interface.
Synopsis sflow sample-rate sample rate
no sflow sample-rate
Operands sample rate
Defaults The default is the current global default sampling in packets.
Command Interface Mode
Modes
Description Use this command to change the default sampling rate for a specific interface.
Usage This command changes the sampling rate for an interface. By default, the sampling rate of an
Guidelines interface is set to the same value as the current global default sampling rate. If the value entered is
not a correct power of 2, the command generates an error message with the previous and next
power-of-2 value. Select one of these two numbers and re-enter the command.
Use the no sflow sample-rate command to return to the default setting.
Examples To change the sampling rate to 4096:
See Also sflow sample-rate (global version)
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the sampling rate value in packets. The range of valid values is
2-8388608.
switch(conf-if-te-0/1)#sFlow sample-rate 4096
sflow sample-rate (interface version)
13
223