Configure A Username And Password; Configure The Enable Password - Dell Force10 S2410-01-10GE-24P Quick Start Manual

Step Task
Invoke the (Config-if-ma)#
3
prompt.
Set the IP address and subnet
4
mask of the management
interface.
NOTE: Creating a management IP address is supported by both the Layer 2
(Switching) and Layer 3 (Routing) licenses of SFTOS.
By default, the management address is reachable from all ports on the default
VLAN, VLAN 1. One or more ports in that VLAN must be enabled.
After you enable and connect ports in the management VLAN and configure the
management IP address, you can manage the switch through a variety of means.

Configure a Username and Password

The username passwd command creates the username and password in one
statement. You can change a password either by reentering the command with
the new password or by removing the user with the no username command and
reentering the user with a new password.
Step Task
Configure a username and
1
password.
Removing a username.
2

Configure the Enable Password

The Privileged Exec password (commonly called the "enable" password), is not
set when the S2410 starts for the first time. To set the enable password, access
the Privileged Exec mode (also called "enable mode") and then the Global
Config mode. Enter the enable passwd command, then press Enter.
18
Installing the Software
Command Syntax
interface
managementethernet
ip address ipaddr
subnetmask
Command Syntax
username passwd
no username
Command Mode
Global Config
(Config-if-ma)#
prompt within the
Global Config
mode
Command Mode
Config
Config