Table of Contents
Advertisement
Note: Every 2 crossed zones must be of the allowed zone type (Interior, Perimeter, Perimeter follower).
The options are: cross zone ON and cross zone OFF (default).
Cross zoning is not applicable in Entry/ Exit zones and 24h zones (Fire, Emergency, 24h audible, 24h silent).
To Enable Cross Zoning
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
ZONING].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [14:CROSS ZONING].
You can now press the
"
" or press the
DEFINE PANEL
4.7.2 Configuring Swinger Stop
Here you determine the number of times each zone is allowed to initiate an alarm within a single arming/disarming period
(including tamper & power failure events of detectors, PowerMax10-G2, wireless siren, etc.). If the alarms number from a
specific zone exceeds the programmed number, the control panel automatically bypasses the zone to prevent recurrent
siren noise and nuisance reporting to the Monitoring Station. The zone will be reactivated upon disarming, or 48 hours after
having been bypassed (if the system remains armed).
Available options are: shut after 1 (default), shut after 2 (default in USA), shut after 3 and no shutdown.
To Configure Swinger Stop
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
STOP].
38
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [14:CROSS
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [13:SWINGER
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
button
.
I
OK
I
OK
".
button
.
I
OK
I
OK
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
14:CROSS ZONING
I
OK
SELECT OPTION
I
OK
14:CROSS ZONING
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
13:SWINGER STOP
D-302756
Advertisement
Table of Contents
