Operation; Maintenance; Replacing The Battery - Visonic KF-234 PG2 Accessories Manual

KF-234 PG2
This section describes how to configure the parameters for home monitoring of people from the PowerMaster-10
control panel.
To Modify the Keyfob Device Settings
Refer to the PowerMaster-10 Installer Guide and perform the procedure for Adding A Wireless Device (section
4.5.2), or, Modifying a Device (section 4.5.5). Then continue below to modify the device settings.
DEV SETTINGS
1.
AUX A
2.
instant
3. or
4.
AUX A

5. OPERATION

Initiate Panic Alarm: Press ARM AWAY and ARM HOME
together for 2 seconds.
Arming Latchkey: Press ARM AWAY/HOME twice.
Arm AWAY/HOME: Press AWAY or HOME button once.
Status: Press ' ' button once.

6. MAINTENANCE

6.1 Replacing the Battery

A replacement 3V battery, CR-2032, is available from hardware and electrical supply stores. Replace the battery
as shown in Figure 3.
Caution! Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the
manufacturer's instructions.
4
Here you select the function of the AUX button on the KF-234 PG2 keyfob.
Select between "instant", "skip exit delay" and "PGM".
When exiting "
ZONES / DEVICES
displays the number of devices that need to be updated, as follows: DEV
UPDATING NNN.
For detailed instructions on Adding Devices, Deleting Devices, Replacing
Devices and Defining Defaults see the PowerMaster-10 Installer Guide.
1
Button pad (Make sure that
it remains in its place)
" menu the PowerMaster-10 system
ARM
"AWAY"
ARM
"HOME"
Remove backside screw
and open the cover.
LED
DISARM
AUX
Figure 2: Operation
D-302758