Replacing A Device - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

11.
Z01: SET CHIME
12.
Chime off....
13. or
melody-chime
14.

4.5.6 Replacing a Device

This feature is used for replacing a device that is enrolled in the system with another device of the same type
while keeping the same parameters of the original device. This can save valuable time, since instead of having
to delete the original device from the control panel, then to enroll the new device and then to set the device
parameters again – all this can now be performed in one short procedure.
To Replace a Device
1.
ZONES/DEVICES
2.
ADD NEW DEVICES
3. or
REPLACE DEVICES
4.
CONTACT SENSORS
5. or
CONTACT SENSORS
6.
Z01: Contact Sens
ID No. 100-2340
or
7
8.
D-302756
Press to change chime settings or press the
skip.
Select between "CHIME OFF" and "melody-chime".
Note: In "melody chime" mode when a chime zone is triggered, chime
melody is heard
You can now press the
same type, or press the
device (see the Accessories Guide for instructions), or press the
button to take you to "
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select the desired device type to be replaced. Select between "CONTACT
"MOTION
SENSORS",
"SIRENS" or "REPEATERS", for example, "CONTACT SENSORS".
The PowerMaster-10 display will read the name of the first enrolled
device of the selected type to be replaced alternating with the ID number
of the device.
At this stage you can select another device of the same type (in this
example, contact sensor) to be replaced.
button to modify the next device of the
button to configure the parameters of the
".
"SMOKE
SENSORS",
button to
"KEYFOBS",
SENSORS",
23