Modifying Or Reviewing A Device - Visonic PowerMaster-10 Installer's Manual

– Deleting a Device
[1]
Enter the Installer Menu, select the "02.ZONES/DEVICES" option (see section 3.2) and then select the
"DELETE DEVICES" option.
[2]
Select the respective Group of the device you wish to delete i.e. "CONTACT SENSORS", "MOTION SENSORS",
"GLASSBREAK SENS.", "SMOKE SENSORS", "CO SENSORS", "GAS SENSORS", "FLOOD SENSORS",
"TEMPERATURE SENS", "WIRED SENSORS", "TAGS(Proximity)", "KEYFOBS", "KEYPADS", "SIRENS" and
"REPEATERS". For example, "MOTION SENSORS".
[3] Scroll the Device Group, identify (by zone and/or ID number) the exact device you wish to replace, for
example: "Z01: Motion Sensor > ID No. 120-1254" and press the
[4]
The display prompts you

3.4.4 Modifying or Reviewing a Device

To Modify or Review the device parameters proceed as follows:
Step 1
Select "MODIFY
[1]
DEVICES" Option
02.ZONES/DEVICES
MODIFY DEVICES
– Modifying or Reviewing a Device
[1]
Enter the Installer Menu, select the "02.ZONES/DEVICES" option (see section 3.2) and then select the
"MODIFY DEVICES" option.
[2]
Select the respective Group of the device you wish to review or modify i.e. "CONTACT SENSORS", "MOTION
SENSORS", "GLASSBREAK SENS.", "SMOKE SENSORS", "CO SENSORS", "GAS SENSORS", "FLOOD SENSORS",
"TEMPERATURE SENS", "WIRED SENSORS", "KEYFOBS", "KEYPADS" and "SIRENS". For example, "MOTION
SENSORS".
[3] Scroll the Device Group, identify (by zone and/or ID number) of the exact device you wish to modify or review,
for example:
"Z10: Motion Camera > ID No. 140-1737".
[4] From here on the process is same as the configuration process that follows the enrollment of that device. To
continue, refer to Section 3.4.2 "Adding a New Wireless Device" Part B Step 6. When done, the display will
show the next device of the same type (i.e. "Motion camera").
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
<OFF> TO DELETE
Step 2
Select the respective
[2]
device Group
CONTACT SENSORS
MOTION SENSORS
. To delete the device, press the
Step 3
Select exact device
[3]
you wish to modify
Z10:Motion Camra
ID No. 140-1737
button.
(OFF) button.
Step 4
Select the Parameter
[4]
you wish to modify
Z10:LOCATION
Z10:ZONE TYPE
Z10:SET CHIME
Z10:DEV SETTINGS
Step 5
Modify the
Parameter
See [4]
When
done
to Step
3
41