Modifying A Device - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

7.
(OFF) to delete
8.
MOTION SENSORS

4.5.5 Modifying a Device

D. To Modify a Device
Note: This procedure is applicable to detectors only.
1.
ADD NEW DEVICES
2. or
MODIFY DEVICES
3.
CONTACT SENSORS
4. or
Z01:Motions Sens
5.
Z01:LOCATION
6.
Front door
or
7.
Master Bdrm
8.
Z01:ZONE TYPE
9.
12.Non-Alarm
10
or
3. Home Delay
22
The device is deleted from the PowerMaster-10 system.
When exiting "ZONES / DEVICES" menu the PowerMaster-10 system
displays the number of devices that need to be updated, as follows: DEV
UPDATING NNN.
You can now press the
type, or press the
button to take you to "
Repeat steps 1 to 3 in section 4.5.2 "Adding a Wireless Device".
Select the desired sensor to be modified. Select between "CONTACT
SENSORS", "MOTION
SENSORS", for example, "MOTION SENSORS".
The PowerMaster-10 display will read "Front door".
Select a location, or, enter the location number, for example,
"Master Bdrm".
Select a zone type, or, enter the zone type number, for example,
pressing 03 selects "3. Home Delay".
To understand the behavior of each zone, see section 4.5.2.3 Zone
Types.
button to delete the device of the same
button to delete a different device, or press the
".
<OK> TO EXIT
SENSORS", "SMOKE SENSORS" and "WIRED
D-302756