Table of Contents
Advertisement
You can now press the
press the
button to delete a different device, or press the
take you to "
<OK> TO EXIT
4.4.5 Modifying a Device
D. To Modify a Device
Note: This procedure is applicable to detectors only.
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
5.
When the PowerMax10-G2 display reads [ZONES/DEVICES] press
The PowerMax10-G2 display will read [ADD NEW DEVICES].
6.
When the PowerMax10-G2 display reads [ADD NEW DEVICES], press the
or
DEVICES].
7.
Press
.
I
OK
The PowerMax10-G2 display will read [CONTACT SENSORS].
8.
Press the
or
modified. Select between "CONTACT SENSORS", "MOTION SENSORS", "SMOKE
SENSORS" and "WIRED SENSORS", for example, "MOTION SENSORS".*
9.
When the PowerMax10-G2 display reads [Z01:Motion Sens] press
The PowerMax10-G2 display will read [LOCATION].
10.
Press
The PowerMax10-G2 display will read [Z01: LOCATION].
I
OK
.
11.
When the PowerMax10-G2 display reads [LOCATION], press
The PowerMax10-G2 display will read [Front door].
Press the
12.
location number, for example, "Master Bdrm".
13.
Press
to confirm. The PowerMax10-G2 display will read [Z01:ZONE
I
OK
TYPE].
14.
When the PowerMax10-G2 display reads [Z01: ZONE TYPE], press
The PowerMax10-G2 display will read [12.Non-Alarm].
15.
Press the
the zone type number, for example, pressing 03 selects "3. Home Delay".
To understand the behavior of each zone, see section 4.4.2.3 Zone Types.
16.
Press
to confirm. The PowerMax10-G2 display will read [SET CHIME].
I
OK
Press
to change chime settings or press the
17.
I
OK
18
button to delete the device of the same type, or
I
OK
".
button and select the [ZONES/DEVICES] option.
button repeatedly until the display will read [MODIFY
button repeatedly to select the desired sensor to be
or
button repeatedly to select a location, or, enter the
or
button repeatedly to select a zone type, or, enter
button to
button
.
I
OK
I
OK
.
I
OK
.
I
OK
.
I
OK
button to skip.
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
ZONES/DEVICES
I
OK
ADD NEW DEVICES
or
MODIFY DEVICES
I
OK
CONTACT SENSORS
or
Z01:Motion Sens
I
OK
Z01: LOCATION
I
OK
Front door
or
Master Bdrm
I
OK
Z01:ZONE TYPE
I
OK
12.Non-Alarm
or
3. Home Delay
I
OK
Z01: SET CHIME
I
OK
D-302756
Advertisement
Table of Contents
