Deleting Device And Keyfob Ids - Visonic POWERMAX Programming Manual

Keyfob transmitter enrolling involves the following steps:
A. Perform Steps A through C in Para. 3.2 above, until the
display reads:
E N R O L L W L D E V I C E
B. Click <NEXT>. The display will read:
E N R O L L K E Y F O B
C. Click <OK>. The display will read:
K e y f o b N o :
D. Suppose that the Keyfob you are about to enroll is to be
designated as Keyfob No. 5. Assuming that memory
location No. 5 is free - no keyfob has yet been enrolled
to it - click the <5> key. The display will change to:
K e y f o b N o :
The clear space at the far right tells you that the
memory location is free.
E. Click <OK>. The display will prompt you to initiate a
transmission from the chosen keyfob:
T R A N S M I T N O W
F. Initiate a transmission from the chosen keyfob by
pressing any one of its pushbuttons. In response, the
"Happy Tune" (- - - –––) will sound and the display will
change to:
K e y f o b N o :
A dark box will appear at the far right, indicating that
the chosen Keyfob has been enrolled as Keyfob No. 5.
Note: If the same keyfob is already enrolled elsewhere,
the "Happy Tune" will sound twice in succession.
G. From this point on, you may continue in several
different directions:
• If you wish to enroll another keyfob, select
the desired number by:
- Clicking <NEXT> to go up (6
- Clicking <BACK> to go down (4
- Clicking <HOME>
After that, proceed as in the example above.
• To delete keyfob IDs, refer to Para. 3.4.
• To return to the main menu, click
<AWAY>. This will bring back the display:
< O K > T O E X I T
You may now review and select any other
mode on the installer's menu (by clicking
<NEXT> or <BACK>).
4
_
5
5
7 8.....)
% %
3 2.....)
% %
<keyfob #>.
%

3.4 Deleting Device and Keyfob IDs

Occupied zones or keyfob memory locations must be
cleared (enrolled ID must be deleted) before enrolling a
new ID. To delete an existing ID, proceed as follows:
A . Select the desired zone or memory location. If, for
example you selected Zone No. 15, or keyfob No. 8,
the display will read:
Z o n e N o .
or, in the other case:
K e y f o b N o .
B. Click <OK>. The display will change to:
< O F F > t o d e l e t e
C . Click <OFF>. The display will change to:
Z o n e N o .
or, in the other case:
K e y f o b N o .
Note that the dark box at the far right has disappeared.
It is now possible to enroll a new ID. It is also possible
to leave the cleared zone or memory location free, and
return to the main menu.
1 5
8
1 5
8
DE5450P