Table of Contents
Advertisement
The PowerMax10-G2 display reverts to "
sounds.
You can now press the
"
" or press the
DEFINE PANEL
4.4 Zones / Devices
4.4.1 General Guidance
The ZONES / DEVICES mode enables the following functions:
- Defining default parameters common for each devices family.
- Adding new devices (enrolling) and defining their zones name, zone type and chime zone.
- Deleting devices.
- Modifying devices parameters.
- Reviewing devices parameters.
Enrolling can be performed for Keyfobs (multi-button), wireless detectors, wireless sirens and repeaters.
The control panel enables entering a device identification (ID) instead of enrolling an actual device. This enables pre-enrolling off
site.
Upon boot up, the control panel checks if there are pre-enrolled devices that have not yet been registered (ID of the devices are
entered but the devices have not communicated with the control panel). In this case, the control panel will display "SYNC WITH
DEV" on the LCD and the trouble LED will be on until all the devices have registered or the pre-enrolled devices that have not
registered will be deleted from the enrollment menu.
Refer to sections 4.4.3 and 4.4.4 for detailed instructions on Enrolling/Deleting a device.
Notes
- Keyfob enrolling can be performed also by the user (via USER SETTINGS menu).
- Wired magnetic contact or any other contact can be enrolled in zones 29 & 30.
- Wireless detectors can be enrolled in zones 01-28.
Before beginning, gather all the devices that you intend to enroll and make sure they all have batteries installed.
Your control panel must recognize the unique identification code (ID) of each such detector in order to supervise them,
receive their signals and respond accordingly.
• Before enrolling, the lens at the front of PIR and dual-technology sensors should be masked to prevent inadvertent
transmission.
• Make sure that magnetic contact transmitters are together with their magnets, to prevent them from sending out alarm
transmissions.
4.4.2 Adding a Wireless Device
This section describes how to add a new device to the PowerMax10-G2 control panel.
Note: It is much easier to enroll the device while holding the device in your hand, close to the control panel.
A. To Add a Device
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
The PowerMax10-G2 display will read [NEW INSTL CODE].
4.
Press the
button and select the [ZONES/DEVICES] option.
5.
When the PowerMax10-G2 display reads [ZONES/DEVICES] press
The PowerMax10-G2 display will read [ADD NEW DEVICES].
6.
Press
You are now instructed to enroll the device.
I
OK
.
Enter the 7-digit number printed on the back side of the device and press
7.
I
OK
.*
or
Perform the enrollment sequence for the specific device:
For most devices: Remove the device bracket or cover and press the device's
12
" and a "Happy Tune"
23:DURESS
or
button to program any other menu in
button to take you to "
☺
".
<OK> TO EXIT
button
.
I
OK
I
OK
23:DURESS
☺
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
NEW INSTL CODE
ZONES/DEVICES
I
OK
ADD NEW DEVICES
I
OK
ENROLL NOW or
ENTER ID No
I
OK
D-302756
Advertisement
Table of Contents
