Zones / Devices; General Guidance; Adding A Wireless Device - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4.5 Zones / Devices

4.5.1 General Guidance

The ZONES / DEVICES mode enables the following functions:
- Defining default parameters common for each devices family.
- Adding new devices (enrolling) and defining their zones name, zone type and chime zone.
- Deleting devices.
- Modifying devices parameters.
- Reviewing devices parameters.
Enrolling can be performed for Keyfobs (multi-button), wireless detectors, wireless sirens and repeaters.
The control panel enables entering a device identification (ID) instead of enrolling an actual device. This enables pre-
enrolling off site.
Upon boot up, the control panel checks if there are pre-enrolled devices that have not yet been registered (ID of the
devices are entered but the devices have not communicated with the control panel). In this case, the control panel will
display "SYNC WITH DEV" on the LCD and the trouble LED will be on until all the devices have registered or the pre-
enrolled devices that have not registered will be deleted from the enrollment menu.
Refer to sections 4.4.3 and 4.4.4 for detailed instructions on Enrolling/Deleting a device.
Notes
- Keyfob enrolling can be performed also by the user (via USER SETTINGS menu).
- Wired magnetic contact or any other contact can be enrolled in zones 29 & 30.
- Wireless detectors can be enrolled in zones 01-28.
Before beginning, gather all the devices that you intend to enroll and make sure they all have batteries installed.
Your control panel must recognize the unique identification code (ID) of each such detector in order to supervise
them, receive their signals and respond accordingly.
• Before enrolling, the lens at the front of PIR and dual-technology sensors should be masked to prevent inadvertent
transmission.
• Make sure that magnetic contact transmitters are together with their magnets, to prevent them from sending
out alarm transmissions.

4.5.2 Adding a Wireless Device

This section describes how to add a new device to the PowerMaster-10 control panel.
Note: It is much easier to enroll the device while holding the device in your hand, close to the control panel.
A. To Add a Device
1.
2.
ZONES/DEVICES
3.
ADD NEW DEVICES
4.
5.
ENROLL NOW or
ENTR ID: XXX-XXXX
16
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
You are now instructed to enroll the device.
Enter the 7-digit number printed on the back side of the device and press
.*
or
Perform the enrollment sequence for the specific device:
For most devices: Remove the device bracket or cover and press the
device's Enroll button continuously until the red & green LEDs turn ON
and then release. The PowerMaster-10 will indicate the result on its LCD
display.
For Keyfobs: Press the '*' button until the red LED blinks rapidly and then
release (the LED will continue blinking) then press the same button again.
The LED lights green and the PowerMaster-10 will indicate the result on its
LCD display.
D-302756