Panasonic MINAS A5-series Operating Instructions Manual page 7

In the case of the motor with shaft end keyway, do
not touch the keyway with bare hands.
Do not touch the rotating portion of the motor
while it is running.
Do not touch the motor, servo driver, heat sink
and regenerative resistor, since they become very
hot.
Do not drive the motor with external power.
Do not subject the cables to excessive force,
heavy object, or pinching force, nor damage the
cables.
Installation area should be free from excessive
dust, and from splashing water and oil.
Mount the motor, driver and regenerative resistor
on incombustible material such as metal.
Wiring has to be carried out by the qualified and
authorized specialist.
Correctly run and arrange wiring.
After correctly connecting cables, insulate the live
parts with insulator.
Ground the earth terminal of the motor and driver
without fail.
Install and mount the Product and machinery
securely to prevent any possible fire or accidents
incurred by earthquake.
Install an emergency stop circuit externally so that
you can stop the operation and shut off the power
immediately.
Install an overcurrent protection, earth leakage
breaker, over-temperature protection and emer-
gency stop apparatus without fail.
Check and confirm the safety of the operation
after the earthquake.
Before transporting, wiring and inspecting the
driver, turn off power and wait for a time longer
than that specified on the name plate on the side
panel of the product; and make sure that there is
no risk of electrical shock.
Failure to observe this instruc-
tion could result in personal
injury.
Failure to observe this instruc-
tion could result in burns.
Failure to observe this instruc-
tion could result in fire.
Failure to observe this instruc-
tion could result in electrical
shocks, damages and break-
downs.
Failure to heed this precaution
will result in electric shock, per-
sonal injury, fire, malfunction or
damage.
Installation on a flammable ma-
terial may cause fire.
Allowing a person with no ex-
pertise to carry out wiring will
result in electrical shocks.
Incorrect wiring will result in
short circuit, electric shock, per-
sonal injury, etc.
Incorrect wiring will result short
circuit, electric shock, fire or
malfunction.
Floating ground circuit will
cause electric shock.
Failure to heed this requirement
will result in electric shock, per-
sonal injury, fire, malfunction or
damage.
Failure to heed these require-
ments will result in electric
shock, personal injury or fire.
Energized circuit will cause
electric shock.
1
2
3
4
5
6
7
7