Brushless Motor MINAS-BL GV ・ GP Series • Thank you very much for your purchase of Panasonic product. • Please read this instruction manual carefully for proper use. • In particular, be sure to read Safety precautions (P.E2 to E5) before use for safety.
Safety Precautions Do not attempt to touch the keyway with bare Please observe safety precautions fully. hands when it is provided on a shaft end of a Failure to observe this instruction motor or gear head. could result in personal injury. Do not touch the rotating portion of the motor The following explanations are for things that must be observed in order to while it is running.
Page 3
Safety Precautions Please observe safety precautions fully. Caution Make an appropriate mounting of the Product The failure to heed this instruction matching to its wight and output rating. can result in personal injury or Observe the specified mounting method and malfunction.
Introduction Product designation Product Overview Checking the model of Motor, Amplifier and Gear head This amplifier is designed for use in combination with a motor to be specified by us. This motor is brushless type. Carefully read through this manual so that you will properly Check a name of series, rated output, voltage specifications you wish to use and safely operate it for a long term.
Product designation/ Name of each part Installation Checking the model number of brushless motor This section describes the installation guidelines and the various considerations that must be taken into account when planning the installation. Nameplate Transport Motor type S1: Continuous rating C O N T.
Installation Wiring Environmental condition Wiring Item Condition Standard wiring diagram Ambient temperature –10 ℃ to 40 ℃ (free from freezing) • In Case of 3-Phase 200 V Ambient humidity 20% to 85% RH (free from condensation) Storage temperature At normal temperature and normal humidity GV series Protection structure IP65 (Excluding shaft pass-through section and lead wire connector)
Page 7
Wiring Maintenance/inspections • In case of single-phase 100 V/200 V Routine maintenance and inspection are essential for proper and satisfactory operation of the motor. GV series Brushless Notes to maintenance/inspection personnel Connector amplifier External speed setting for control Variable resister 5 kΩ signals (I/O) Power •...
Page 8
Conformance to EC directive and UL standard Conformance to EC directive and UL standard/ Specifications EC Directives Wiring of peripheral equipment The EC directives apply to all such electronic products as those having specific functions Ferrite core (Noise filter for signal line) and directly sold to general consumers in EU countries.
Specifications Outline dimensional drawing (Unit: mm) • Gear head • Gear head <MX8G□B> <MB8G□BV> (For GV series 50 W motor - sold separately) (For GP series 50 W motor - sold separately) ・ □: Reduction ratio shown below: ・ □: Reduction ratio shown below: ・...
Page 10
Cautions for Proper Use MEMO Cautions for Proper Use • Practical considerations for exporting the product or assembly containing the product When the end user of the product or end use of the product is associated with military affair or weapon, its export may be controlled by the Foreign Exchange and Foreign Trade Control Law.