Tunnel Source - Dell Networking 7048 Reference Manual

console(config-if-tunnel1)#tunnel mode ipv6ip
console(config-if-tunnel1)#tunnel mode ipv6ip 6to4

tunnel source

Use the tunnel source command in Interface Configuration mode to specify
the source transport address of the tunnel, either explicitly or by reference to
an interface.
Syntax
ip-address
tunnel source {
no tunnel source
Syntax Description
Parameter
ip-address
interface-type
interface-number
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies VLAN 11 as the source transport address of
the tunnel.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel source vlan 11
interface-type interface-number
|
Description
Valid IPv4 address.
Valid interface type. VLAN is the only type supported.
Valid interface number.
Tunnel Interface Commands
}
1327