Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual page 57

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Error Logs, Access Logs, and System Inventory
Error Logs
Table 2-2 Continued
Error
Codes Description
0009 FRIGID START:
System was restarted and initialized
to default programming.
This error is also logged after a
System Erase.
000A POWER UP COLD START:
A RAM failure was detected in the
processor.
System programming is okay.
000B CARD INSERTED/REMOVED:
000C SLOT STREAM CNT EXCEEDED:
Slot has generated excessive
interrupts.
000D FMWR NOT IN STANDBY MODE:
Module firmware is not in standby
mode.
000E COMMAND BUFFER FULL:
000F TASK RUNNING TOO LONG:
0010 INVALID SLOT INTERRUPT:
Cannot determine module
responsible for generating the
interrupt.
0011 STACK OVERFLOW:
Processor problem.
Action
If the processor was removed while in
use, the system may perform a frigid
start due to loss of system programming.
Restore system as described in System
Programming and Maintenance (SPM) ,
or in Appendix D, ''Backing Up with a
Memory Card''.
If problem persists, troubleshoot the
processor.
No action required.
If problem persists, troubleshoot the
module.
If problem persists, troubleshoot the
module.
If problem persists, troubleshoot the
processor and module.
No action required: however, if problem
persists, troubleshoot the processor.
Troubleshoot modules and replace if
necessary. If problem persists,
troubleshoot the processor.
Troubleshoot the processor.
Continued on next page
Issue 1
June 1997
Page 2-7