Outgoing Data Call Test - Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Control Unit Problems
800 NI-BRI Module Problems

Outgoing Data Call Test

Place a data call from the BRI line under test to either a working facility on the
system or a data endpoint on the premise that is connected to the central office
(CO). See the Data and Video Reference for details regarding setting up a data
call with specific equipment.
NOTE:
The 800 NI-BRI module must be restored (removed from the Maintenance
Busy state) before performing this test.
Assign the BRI line to a data terminal.

If using a facility on the system as a destination, assign the destination
facility to another data terminal.
Dial the destination number. (In a Centrex environment, it is

necessary to dial a 9 before the destination number.)
Verify the following results and note any failures:
Answer the call at the destination telephone and verify the

connection.
The destination data station may be programmed for auto-answer. Verify
that the red and green LEDs next to this button are on steady and the
communication path is established.
You may hear dial tone at the beginning of dialing and ringback
after completion. Alerting may be indicated at the destination.
If both ringback and alerting are absent, check that the dialed
digits are those of the destination DN. Redial, if necessary. If the
call could not be established and the dialing was correct, record
that an outgoing data call cannot be completed from this line and
indicate the type of tone, if any, that was present at both ends.
If the destination telephone can display calling party number,
verify that the DN of the BRI line under test is displayed correctly.
If not, record that the calling party information displayed at the
destination telephone is incorrect or absent.
Issue 1
June 1997
Page 4-100