Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual page 30

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Introduction
Using SPM
Pick up the handset on the T/R telephone and dial the remote

access trunk number.
This is possible only if a trunk is programmed as a dedicated trunk for
remote access to the built-in modem.
If the dial tone begins with three short tones followed by a steady

tone, dial the remote access barrier code from the T/R telephone;
otherwise, go to Step 5.
If you do not know the remote access barrier code, contact the
customer's system manager, or check Form 3a, Incoming Trunks:
Remote Access. If the system accepts the barrier code, you hear ringing
followed by dial tone.
NOTE:
You can change the barrier code without knowing the old one only when
you perform on-site maintenance through the ADMIN jack.
Connect to the modem on the remote system.

When you hear dial tone, dial
When you hear the modem tone, hang up.

If nothing appears on the SPM screen, press
*10 .
P
Issue 1
June 1997
Page 1-12
.