Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual page 122

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Control Unit Problems
Processor Problems
Reconnect the D8W cord(s) connecting the SMDR printer and/or

system programming PC.
Attach a tag to the old processor.

Use the tag to identify any visible problems and relevant error reports.
Replacing the Feature Module
NOTE:
This section applies only to releases earlier than Release 3.0.
!
CAUTION:
Make sure that you have a backup of system programming before
replacing the feature module. See
Programming''.
To replace the feature module, follow the steps below.
Make sure system power is off.

Remove the processor from the carrier.

a. Press up on the tab on the bottom rear of the module.
b. Pull the bottom of the module away from the carrier.
c. Lift upward to disengage the module from the rod on the top of the
Place the processor on a flat surface.

The backup floppy disk or original system programming disk. See
System Programming and Maintenance for instructions.
The backup memory card or original system programming
memory card (Release 3.0 and later). See
Up with a Memory Card''
carrier.
, for instructions.
''Backing Up System
Issue 1
June 1997
Page 4-32
Appendix D, ''Backing