Processor Key Mode - Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual
Communications system
Hide thumbs
Also See for MERLIN LEGEND Release 5.0:
- System programming manual (949 pages) ,
- Feature reference (869 pages) ,
- System planning manual (394 pages)
Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 5.0
MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Maintenance and Troubleshooting
Modifying A Release 2.1 or Earlier Processor Key Mode
Modifying A Release 2.1 or Earlier
E
Processor Key Mode
Release 2.1 and Earlier
!
CAUTION:
This procedure must be performed for KF registration with the FCC.
This procedure prevents the system from being programmed as a
Hybrid-PBX system. Do this only if the system is programmed for Key
mode and GS trunks are not indicated on Form 2c, System Numbering:
Line/Trunk Jacks.
To modify the processor for Permenant Key mode, follow the steps below. Refer to
Figure
E-1.
Remove the processor from its packaging.
Place the processor on a flat surface.
If the feature module is installed, remove it.
See
''Replacing the Feature Module''
in
Chapter 4
for instructions.
Issue 1
Issue 1
June 1997
June 1997
Page E-1
E
Advertisement
Table of Contents
Need help?
Do you have a question about the MERLIN LEGEND Release 5.0 and is the answer not in the manual?