Lucent Technologies MERLIN LEGEND Release 5.0 Maintenance And Troubleshooting Manual page 344

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting 555-650-140
Backing Up with a Memory Card
Restore
Restore
Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation card is
copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the current
set.
The processor module is replaced.
After a System Erase (frigid start) has been performed.
The system software has been reinstalled.
The Inspect feature (Inspct or
files on the memory card prior to initiating the restore procedure. The attributes
included on the Inspect screen are the filename, the time and day of the file
backup/update, the location of the system programming port, and information about
the system software release from which the backup was made.
If any type of programming is taking place at another extension when you begin the
restore procedure, the restore is canceled and the number of the busy extension
appears on the screen. Repeat the restore procedure when the busy extension
becomes idle.
If a line is busy (incoming call or active call) when you begin the restore procedure,
the restore is canceled and the number of the active line appears on the screen.
Repeat the restore procedure when the line becomes idle.
Also see ''Restore Messages''
the restore procedure.
) is available to view the attributes of the backup
h
for information about errors that may occur during
Issue 1
June 1997
Page D-20