Defining QoS Settings Using the CLI Commands
Table 10-3. CLI Commands for Defining QoS Settings
CLI Command
qos [ advanced ]
show qos
qos cos default-
cos
The following is an example of the CLI commands:
Console(config)# qos
Console(config)# interface ethernet g5
Console(config-if)# qos cos 3
Console(config-if)# exit
Console(config)# exit
Console# show qos
QoS: basic
Basic trust: vpt
Description
Enables/disables QoS in basic /advanced mode
for the entire device.
Displays the QoS mode for the entire device.
Configures the default CoS value for the
interface.
Configuring Quality of Service
429