Dell PowerConnect 6024 User Manual page 111

Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Broadcast Interface Table.
NOTE:
When defining Anycast or Broadcast interfaces, at least one IP address must be defined.
Table 6-8. SNTP interface Settings CLI Commands
CLI Command
sntp client enable
show sntp
configuration
The following is an example of the CLI commands for configuring SNTP interfaces:
Console (config)# interface ethernet g1
Console (config-if)# sntp client enable
Console (config-if)# end
Console# show sntp configuration
Polling interval: 7200 seconds.
MD5 Authentication keys: 8, 9
Authentication is required for synchronization.
Trusted Keys: 8,9
Unicast Clients Polling: Enabled.
Server
-----------
176.1.1.8
176.1.8.179
Broadcast Clients: Enabled
Broadcast Clients Poll: Enabled
Broadcast Interfaces: g1
Description
Enables the Simple Network Time Protocol
(SNTP) broadcast and anycast client on an
interface.
Displays the SNTP configuration.
Polling
--------
Enabled
Disabled
Encryption Key
-----------------
9
Disabled
Configuring System Information
121