Dell PowerConnect 6024 User Manual page 312

Assigning LAGs to Receive Multicast Service
1
Open the Bridge Multicast Group page.
2
Define the VLAN ID and the Bridge Multicast Address fields.
3
Toggle the LAG to S to join the LAG to the selected multicast group.
4
Toggle the LAG to F to forbid adding specific multicast addresses to a specific LAG.
5
Click Apply Changes.
The LAG is assigned to the multicast group, and the device is updated.
Managing Multicast Service Members Using CLI Commands
The following table summarizes the equivalent CLI commands for managing Multicast service
members as displayed in the Bridge Multicast Group page.
Table 7-33. Multicast Service Member CLI Commands
CLI Command
bridge multicast address
{ mac-multicast-address |
ip-multicast-address } [add
| remove] {ethernet
interface-list | port-
channel port-channel-
number-list }
bridge multicast forbidden
address { mac-multicast-
address | ip-multicast-
address } [add | remove]
{ethernet interface-list |
port-channel port-channel-
number-list }
show bridge multicast
address-table [vlan vlan -
id ] [address mac-multicast-
address | ip-multicast-
address ] [format ip | mac]
The following is an example of the CLI commands:
console#config
console(config)#vlan database
console(config-if)#vlan 8
console(config-if)#exit
322
Configuring Switch Information
Description
Registers MAC-layer multicast
addresses to the bridge table, and
adds static ports to the group.
Forbids adding a specific multicast
address to specific ports. Use the no
form of this command to return to
default
Displays Multicast MAC address
table information.