Dell PowerConnect 6024 User Manual page 328

3
Define the fields.
See "Configuring VRRP" for information about the fields.
NOTE:
4
Click Apply Changes.
The new VRRP interface is added, and the device is updated.
NOTE:
added. It is recommended that you delete this entry from the virtual routers table.
Modifying VRRP Routers
1
Open the Virtual Router Redundancy Protocol (VRRP) page.
2
Select an interface in the Interface field.
3
Define the fields as desired.
4
Click Apply Changes.
Deleting a VRRP Entry
1
Open the Virtual Router Redundancy Protocol (VRRP) page.
2
Click Show All to display the VRRP Table.
3
Select a table entry.
4
Check the Remove check box.
5
Click Apply Changes.
The VRRP entry is deleted, and the device is updated.
Configuring VRRP Using the CLI Commands
The following table contains the CLI commands for configuring the VRRP.
Table 8-3. VRRP CLI Commands
CLI Command
vrrp virtual-router ip
ip-address [ ip-
address2...ip-address8 ]
vrrp virtual-router up
vrrp virtual-router
timer seconds
vrrp virtual-router
priority priority
338
Configuring Routing
VRRP interfaces must be defined before the admin state can be Enabled.
If an illegal virtual IP address is entered, a warning will display, but the virtual router will be
Description
Defines Virtual Router Redundancy Protocol
(VRRP) for an interface.
Activates Virtual Router Redundancy Protocol
(VRRP) on an interface.
Configures the time interval between sending
advertisements messages.
Configures Virtual Router Redundancy
Protocol (VRRP) priority on an interface.