Table 7-8. Port Configuration CLI Commands
CLI Command
show interfaces
configuration [ethernet
interface | port-channel
port-channel-number oob-
eth interface ]
show interfaces status
[ethernet interface | port-
channel port-channel-
number oob-eth interface ]
show interfaces
description [ethernet
interface | port-channel
port-channel-number oob-
eth interface ]
The following is an example of the CLI commands:
Console (config)# interface ethernet g18
Console (config-if)# description RD_SW#3
Console(config-if)# speed 100
Console (config-if)# shutdown
Console (config-if)# no shutdown
Console (config-if)# duplex full
Console (config-if)# negotiation
Console (config-if)# back-pressure
Console (config-if)# flowcontrol on
Console (config-if)# mdix auto
Console (config-if)# exit
Console (config)# exit
Console> set interface active ethernet g9
260
Configuring Switch Information
Description
Displays the configuration for all
configured interfaces.
Displays the status for all configured
interfaces.
Displays the description for all
configured interfaces.