Configuring Address Tables - Dell PowerConnect 6024 User Manual

4
Click Apply Changes.
The new port mirroring session is enabled for the port, and the device is updated.
Modifying a Port Mirroring Session
1
Open the Port Mirroring page.
2
Modify the fields.
3
Click Apply Changes.
The port mirroring session fields are modified, and the device is updated.
Deleting a Port Mirroring Session
1
Open the Port Mirroring page.
2
Check the Remove check box.
3
Click Apply Changes.
The port mirroring session is deleted, and the device is updated.
Configuring a Port Mirroring Session Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring a Port Mirroring
session as displayed in the Port Mirroring.
Table 7-11. Port Mirroring CLI Commands
CLI Command
port monitor src-interface
[rx | tx]
show ports monitor
The following is an example of the CLI commands:
Console(config-if)# port monitor g2

Configuring Address Tables

MAC addresses are stored in either the static address or the dynamic address database. Static
addresses are defined by the user. Dynamic addresses are learned by the system, and are erased after
a time-out. A packet addressed to a destination stored in one of the databases is forwarded
immediately to the ports. The static and dynamic address tables can be sorted by interface, VLAN,
and interface type. In addition, addresses can be added to the static and dynamic address tables.
To open the Address Tables page, click Switch→ Address Table in the tree view.
Description
Starts a port monitoring session.
Displays status of port monitoring.
Configuring Switch Information
269