Dell PowerConnect 6024 User Manual page 341

Configuring RIP Interfaces Using CLI Commands
The following table contains the CLI commands for configuring the RIP Global Parameters.
Table 8-7. RIP Configuration CLI Commands
CLI Command
rip
rip version {1 | 2}
rip passive-interface
rip auto-send
rip offset offset
rip default-route offset
offset
rip authentication {text
text | md5 name-of-
chain }
show ip rip
show ip rip md5
The following is an example of the CLI commands:
Console (config)# router rip enable
Console(config)# interface ip 100.1.1.1
Console(config-ip)# rip
Console(config-ip)# rip version 1
Console(config-ip)# rip passive interface
Console(config-ip)# rip auto-send
Console(config-ip)# rip offset 5
Console(config-ip)# rip default-route offset 5
Console(config-ip)# rip authorization text dell
Console(config-ip)# exit
Console(config)# exit
Description
Enables RIP on an interface.
Specifies an RIP version.
Disables the sending of routing updates on
an interface.
Automatically detects if RIP information is
required to be sent on the interface.
Adds an offset to a metric learned via RIP
before adding it to the interface table.
Generates a default route into RIP by
applying an offset value.
Enables authentication for RIP Version 2
packets and specifies the authentication
type.
Displays IP RIP information
Displays IP RIP MD5 information.
Configuring Routing
351