Dell PowerConnect 6024 User Manual page 116

Figure 6-17. OOB IP Interface Parameters
The OOB IP Interface Parameters page contains the following parameters:
IP Address—The Out-of-Band interface IP address.
Prefix Length—The number of bits that comprise the source IP address prefix, or the network
mask of the source IP address.
Type—The means by which the Out-of-Band IP interface was created; DHCP or static.
Remove—When checked, removes the interface from the IP Address drop-down list.
NOTE:
page (System→ IP Address→ DHCP IP Interface).
Adding an IP Interface
1
Open the OOB IP Interface Parameters page.
2
Click Add to display the Add a Static OOB IP Interface page.
3
The Network Mask field specifies the subnetwork mask of the source IP address.
4
Complete the fields in the page.
5
Click Apply Changes.
The new interface is added, and the device is updated.
126
Configuring System Information
You can configure DHCP IP addresses for Out-of-Band management on the DHCP IP Interface