Dell PowerConnect 6024 User Manual page 135

Remove — When checked, removes the interface from the IP Address drop-down menu.
Adding an IP Interface
1
Open the IP Interface Parameters page.
2
Click Add to open the Add a Static IP Interface page.
Figure 6-25. Add a Static IP Interface
3
Complete the fields on the page.
Network Mask specifies the subnetwork mask of the source IP address.
Each part of the IP address must start with a number other than zero. For example, IP addresses
001.100.192.6 and 192.001.10.3 are invalid.
4
Click Apply Changes.
The new interface is added, and the device is updated.
Modifying IP Address Parameters
1
Open the IP Interface Parameters page.
2
Select an IP address in the IP Address drop-down menu.
3
Modify the required fields.
4
Click Apply Changes.
The parameters are modified, and the device is updated.
Deleting IP Addresses
1
Open the IP Interface Parameters page.
2
Click Show All to display the Interface Parameters Table page.
3
Select an IP address and check the Remove check box.
4
Click Apply Changes.
The IP address is deleted, and the device is updated.
Configuring System Information
145